Rug Pads — Mohawk rugs
Non Slip Rug Pad Install
Posted by #AreaRugsWeaver # on
Non slip rug pads should be installed on hard surfaces like hard wood floors, concrete or tile. The main reason a rug pad is installed on these surfaces is to provide frictional grip, so a rug above does not slip and cause an injury to the person walking over. The additional benefit of using the non slip rug pad is also to provide additional comfort or better sound absorption. Some home owners may choose to install a rug pad on wall to wall carpets too, so the rug on top does not bulge up. Here are the steps to follow for a proper Mohawk rug pad install:
Step 1: Find the perfect position of the rug, where you want it to be placed, whether living room , entry door or bedroom.
Step 2: Place your rug pad under the rug on the hard surface like hardwood floor.
Step 3: Foldone end of top rug a little so the rug pad underneath is exposed.
Step 4: With scissors cut the exposed edges of the rug pad two to three inches inside the edge of the rug.
Step 5 : Repeat the proces for all sides. And then unfold the rug, so the rug pad is totally covered and no edges of the rug pad are exposed.
Enjoy walking over the rug, if the rug install instructions are properly followed then your rug pad will provide a long lasting non slip grip between the floor and rug.
- Tags: 8x10 rug pad, 9x12 rug pad, anchor grip rug pad, best rug pad, felt rug pad, Mohawk rugs, rug pad, rug pad 8x10, rug pad usa, rug pads